Mixer Control Room Vs Main Out

There are 3 major solo modes you can encounter on a mixer.

Mixer control room vs main out.

Mixer mbox mini 2 control room and main out questions if this is your first visit be sure to check out the faq by clicking the link above. I connect monitors and headphones via control room out not main out. Click the register link above to proceed. All buttons were depressed except for the main to control room button on the behringer.

Stereo out balanced xlr connections 1 ground 2 hot 3 cold which output the stereo buss signals which can be used to feed the analog inputs of a 2 track recorder or a specialist chain of analog devices used for mastering. Control room speakers are to be hooked up to the large and small 1 4 trs connectors. If you are in the room with the mixer then that is the control room. You may have to register before you can post.

I take sound card out and feed that to the desk tape in which i route to the control room. By doing it this way any changes to listening level are independent of desk settings. Use that to monitor the main out when you need to. Then i tweaked the control room out volume knob on the behringer until it had the same overall gain as the soundcraft.

The main out i use to feed into soundcard. Don t worry about where the control room is. Both are fed on channel 7. 1 2 original message date.

Ok octevio the main outs on a mixer console is your stereo output sockets the connectors are a 3 pin xlr on your larger console but it can also be a 6 5 mm trc jack sockets or rca. It is normally used for setting the gain on channels. Main mix outputs and aux output s are mixes that are sent to yo. 07 jul 01 12 58 am control room vs.

Ok here goes the newbie guide to solo modes. Just give it a go.