Andersen and emco brand storm doors offer mortise hardware that can be locked from both sides of the door panel.
Mortise lock deadbolt stuck.
To learn more about mortise hardware see handle set types and styles used on storm door.
Removing mortise lock trim for door painting or replacement.
If you have questions please ask.
Replace tailpiece on deadbolts and handle sets.
How to install baldwin estate keyed entry adaptor replacement.
Remove the two screws that hold the lock cylinder and pull it from the door.
If that last photo is the deadbolt get a thin flat blade screwdriver or an old table knife and work the latch back into the door.
Mortise lock and trim installation.
Today we are discussing how to remove an entry mortise lock with a thumb latch on the exterior instead of a regular knob.
Ask your own home improvement question by stick the screw driver in the door jam.
Deadbolts can stick for one of a variety of reasons.
Try this method several times until the dead bolt slides back into the lock.
I never did had this problem before and couldn t find a clear cut solution.
Then saturate the bolt mechanism with the spray lube and twist it back and forth with a flat blade screwdriver.
Deadbolts latch into door frames and add an extra layer of security when used in combination with standard doorknob locksets.
If lubing the lock cylinder doesn t free it you ll need to lube the bolt mechanism photo 2.
It s also possible the installation of the deadbolt was imperfect.
So if you are in the sam.
I will see if there is enough space.
Key will spin without operating the deadbolt.
This may free up the parts inside the lock and cause stuck parts to wiggle free.
The lockset itself may be stuck and in need of lubrication or the door may have fallen out of alignment wedging the deadbolt barrel against the wood in the jamb.
Mortise door locks and deadbolts 1 153 products door locks and deadbolts allow doors to be locked to keep building areas secure.
Be sure the strike plate is secure and in reasonable alignment with the bolt.
You can file the edges of the strike plate a little and even slightly round the edges of the deadbolt s end.
You can lock the storm door with your key from the outside or from the inside using the key cylinder thumb turn.
Tap the lock with a small hammer or the end of a screwdriver while you turn the key.
